Ntp-Service Authentication Enable - H3C S5500-EI Series Command Manual

Command Manual – NTP
H3C S5500-EI Series Ethernet Switches
synchronization: Specifies to permit server access only.
acl-number: Basic ACL number, in the range of 2000 to 2999
Description
Use the ntp-service access command to configure the NTP service access-control
right to the local device.
Use the undo ntp-service access command to remove the configured NTP service
access-control right to the local device.
By default, the local NTP service access-control right is set to peer.
From the highest NTP service access-control right to the lowest one are peer, server,
synchronization, and query. When a device receives an NTP request, it will perform
an access-control right match and will use the first matched right.
Note:
The ntp-service access command provides only a minimum degree of security
protection. A more secure method is identity authentication.
Before specifying an ACL number in the ntp-service access command, make sure
you have already created and configured this ACL.
Examples
# Configure devices on the subnet 10.10.0.0/16 to have the full access right to the local
device.
<Sysname> system-view
[Sysname] acl number 2001
[Sysname-acl-basic-2001] rule permit source 10.10.0.0 0.0.255.255
[Sysname-acl-basic-2001] quit
[Sysname] ntp-service access peer 2001

1.1.5 ntp-service authentication enable

Syntax
ntp-service authentication enable
undo ntp-service authentication enable
View
System view
Chapter 1 NTP Configuration Commands
1-6