Ntp-Service Broadcast-Server; Ntp-Service In-Interface Disable - H3C S5500-EI Series Command Manual

Command Manual – NTP
H3C S5500-EI Series Ethernet Switches

1.1.8 ntp-service broadcast-server

Syntax
ntp-service broadcast-server [ authentication-keyid keyid | version number ] *
undo ntp-service broadcast-server
View
VLAN interface view
Parameters
authentication-keyid keyid: Specifies the key ID to be used for sending broadcast
messages to broadcast clients, where keyid is in the range of 1 to 4294967295. This
parameter is not meaningful if authentication is not required.
version number: Specifies the NTP version, where number is in the range of 1 to 3 and
defaults to 3.
Description
Use the ntp-service broadcast-server command to configure the device to work in
the NTP broadcast server mode.
Use the undo ntp-service broadcast-server command to remove the device as an
NTP broadcast server.
Examples
# Configure the device to work in the broadcast server mode and send NTP broadcast
messages on VLAN-interface 1, using key 4 for encryption, and set the NTP version to
3.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] ntp-service broadcast-server authentication-keyid
4 version 3

1.1.9 ntp-service in-interface disable

Syntax
ntp-service in-interface disable
undo ntp-service in-interface disable
View
VLAN interface view
Chapter 1 NTP Configuration Commands
1-9