Download Print this page
Wolf Pro Hood Liner Installation Manual
Hide thumbs Also See for Pro Hood Liner:

Advertisement

Quick Links

P R O H O O D L I N E R
INSTALLATION GUIDE
S P E C I F I C AT I O N S , I N S TA L L AT I O N , A N D M O R E

Advertisement

loading
Need help?

Need help?

Do you have a question about the Pro Hood Liner and is the answer not in the manual?

Questions and answers

Summary of Contents for Wolf Pro Hood Liner

  • Page 1 P R O H O O D L I N E R INSTALLATION GUIDE S P E C I F I C AT I O N S , I N S TA L L AT I O N , A N D M O R E...
  • Page 2: Table Of Contents

    Features and specifications are subject to change at any time without notice. Visit wolfappliance.com/specs for the most up-to-date information. Throughout this guide, dimensions in IMPORTANT NOTE: parentheses are millimeters unless otherwise specified. Save these instructions for the local IMPORTANT NOTE: electrical inspector. 2 | Wolf Customer Care 800.222.7820...
  • Page 3: Pro Hood Liner

    Service with the model and serial number. For the name of rated construction. the nearest Wolf Factory Certified Service or for questions • Two installers are recommended due to the size regarding the installation, visit the Support & Service and weight of the pro hood.
  • Page 4: Specifications

    " below the decorative hood. (19) A make-up air damper is available through an authorized Wolf dealer. For local dealer information, visit the find a showroom section of our website, wolfappliance.com. 4 | Wolf Customer Care 800.222.7820...
  • Page 5 SPE C IF I CAT I ON S Discharge Electrical Requirements Pro Hood Liners have a vertical discharge. Refer to the Installation must comply with all applicable electrical codes. illustration below. Locate the electrical supply as shown in the illustration below.
  • Page 6: Installation

    Refer to the illustration hood and internal blower, if applicable. below. Refer to the illustration below for typical wall framing. BLOCKING MOUNTING HOLE 3 /4 " (273) 5" (127) MOUNTING BACK PANEL HOLE Filters Wall framing (typical) 6 | Wolf Customer Care 800.222.7820...
  • Page 7 IN S TA L L AT I O N Installation Remove the transition from inside the hood by removing Remove the electrical box from the inside of the hood. the hold-down brackets. Remove the shipping material Refer to the illustration below. from the damper.
  • Page 8 Plug the blower power cord into the receptacle inside the hood. Refer to the illustration below. Turn on the power to the hood and verify light and blower operation. RECEPTACLE RECEPTACLE Electrical connections Electrical connections 8 | Wolf Customer Care 800.222.7820...
  • Page 9 IN S TA L L AT I O N Complete the Installation F I LT ER S LI GH T B U LB S Orient the filters with the lines running vertically. To install, A suction-cup-style light bulb changer is provided with place the top edge of the filter against the spring, press the hood.
  • Page 10: Blower Specifications

    3 /4 " 22" 1 /4 1 /4 25" " " 3 /4 " (121) (559) (635) (184) (184) (629) 600 / 900 CFM remote blower 1200 CFM remote blower 1500 CFM remote blower 10 | Wolf Customer Care 800.222.7820...
  • Page 11: Troubleshooting

    Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf & Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
  • Page 12 WOLF APPLIANC E , INC. P.O. BO X 44848 MA D ISON , WI 537 44 W OL FA P P LIA N C E. C OM 8 00. 22 2. 7 8 2 0 0000000 REV-A 8 / 2019...