50313, 50314, 50315, 50316, 50317 and 50318
The 50313, 50315 and 50317 switch panels are designed to be mounted in the dash using
the screws provided.
The 50314, 50316 and 50318 switch panels are designed to be mounted in the box
provided. The assembled box and panel may be attached to the roll cage or any location
convenient for operation. The box may be attached to the roll cage with regular hose
clamps by routing the clamp through the slots precut in the back of the box and then
around the roll bar. No cutting or welding is necessary.
The large red wire, that has been spliced several times, is included in the kit to provide
power to all the switches. The spliced black wire is included to provide a ground to all
the switch Lights.
Individual wires with terminals on one end are the wires to be routed from the switch to
the device being controlled. The terminal end is for the switch and once the wire has been
routed, the extra length may be cut off and then terminated. Each kit has extra switches
and extra wires, which may be needed in your particular application.
The following chart is a guideline to what color wire is normally used for a particular
circuit.
Red; Battery power
Black; Chassis ground
Purple; Starter solenoid
Pink; Ignition coil
White; Accessory
Tan; Headlights
50313-18.doc
Installation Instructions
Universal Switch Panels
E-Mail:
WebSite:http://www.painlessperformance.com
For
Orange; Accessory
Yellow/White; Fuel pump
Green; Fuel pump 2
Blue; Water pump
Gray/White; Electric fan relay
Brown; Tail lights
1
2501 Ludelle Street
Fort Worth, Texas 76105
817-244-6898 phone
817-244-4024 fax
800-423-9696 orders
painless@painlessperformance.com
03-31-03