Advertisement
Figure "A" illustrates the proper hookup of wires using an ON/OFF/ON switch when
two devices are to be operated and one of the devices is to be on in both positions. An
example might be headlights and taillights. With the switch in the lower position only the
taillights are on and in the upper position the headlights and taillights are on.
The diode, in the illustration, allows this function to take place. If the diode is not used,
the switch operates two devices independently.
Note: The MOMENTARY/OFF/ON switch is wired the same as the ON/OFF/ON
SWITCH.
Figure "B" illustrates the proper hookup of wires to an ON/OFF switch, which will
control a single device.
Figure "C" illustrates the proper hookup of wires to a MOMENTARY ON switch,
which can be used to control a starter motor, horn or any device requiring only
momentary voltage. The momentary switch does not have a lighted button so a ground
wire is not required.
The label sheet included is to identify each switch of its function. Simply peel off the
label needed and place it under the switch wired for that function. The "R" and "L" labels
are for right and left in the event an on/off/on switch is used for turn signals.
If your kit has a box for roll bar mounting, the rubber grommet is to be installed in the
hole the wires will be exiting out of and the plastic plugs are to fill the remaining holes.
The plastic wire ties are for looming and securing the wires to the vehicle
The following is included in this kit;
1 switch panel
1 mounting box depending which kit you have
4 or 5 on/off switches depending on which kit you have.
1 or 2 on/off/on switch depending on which kit you have.
1 or 2 momentary/on/off depending on which kit you have.
1 momentary on switch
1 diode assembly
1 sheet of labels to describe switch function
4 mounting screws
1 rubber grommet (kit with boxes only)
3 plugs for box holes not used (kits with boxes only)
4 7" tie straps
100 4" tie straps
7, 9 or 12 color-coded wires for switch attachment
1 red input power wire
1 black (spliced) ground wire.
3
Advertisement
