Advertisement
Quick Links
50313, 50314, 50315, 50316, 50317 and 50318
The 50313, 50315 and 50317 switch panels are designed to be mounted in the dash using
the screws provided.
The 50314, 50316 and 50318 switch panels are designed to be mounted in the box
provided. The assembled box and panel may be attached to the roll cage or any location
convenient for operation. The box may be attached to the roll cage with regular hose
clamps by routing the clamp through the slots precut in the back of the box and then
around the roll bar. No cutting or welding is necessary.
The large red wire, that has been spliced several times, is included in the kit to provide
power to all the switches. The spliced black wire is included to provide a ground to all
the switch Lights.
Individual wires with terminals on one end are the wires to be routed from the switch to
the device being controlled. The terminal end is for the switch and once the wire has been
routed, the extra length may be cut off and then terminated. Each kit has extra switches
and extra wires, which may be needed in your particular application.
The following chart is a guideline to what color wire is normally used for a particular
circuit.
Red; Battery power
Black; Chassis ground
Purple; Starter solenoid
Pink; Ignition coil
White; Accessory
Tan; Headlights
50313-18.doc
Installation Instructions
Universal Switch Panels
E-Mail:
WebSite:http://www.painlessperformance.com
For
Orange; Accessory
Yellow/White; Fuel pump
Green; Fuel pump 2
Blue; Water pump
Gray/White; Electric fan relay
Brown; Tail lights
1
2501 Ludelle Street
Fort Worth, Texas 76105
817-244-6898 phone
817-244-4024 fax
800-423-9696 orders
painless@painlessperformance.com
03-31-03
Advertisement
Related Manuals for Painless Performance Products 50313
Summary of Contents for Painless Performance Products 50313
-
Page 1: Installation Instructions
50313, 50314, 50315, 50316, 50317 and 50318 Universal Switch Panels The 50313, 50315 and 50317 switch panels are designed to be mounted in the dash using the screws provided. The 50314, 50316 and 50318 switch panels are designed to be mounted in the box provided. - Page 2 NOTE: The diode is only needed if you want to send power to both output wires by pushing only one side of the switch. DIODE INSTALLATION: With diode stripe on top (as shown) it will send power out the bottom and top output wires when the top of the switch is pushed, but it will only send power out the top output wire when the bottom side of the switch is pushed.
- Page 3 Figure "A" illustrates the proper hookup of wires using an ON/OFF/ON switch when two devices are to be operated and one of the devices is to be on in both positions. An example might be headlights and taillights. With the switch in the lower position only the taillights are on and in the upper position the headlights and taillights are on.
- Page 4 Painless Performance Limited Warranty and Return Policy Chassis harnesses and fuel injection harnesses are covered under a lifetime warranty. All other products manufactured and/or sold by Painless Performance are warranted to the original purchaser to be free from defects in material and workmanship under normal use. Painless Performance will repair or replace defective products without charge during the first 12 months from the purchase date.