Advertisement
Quick Links
Off-Road Switch Panel
Installation Instructions
50334: Off-road 4 Toggle switches/Dash Mount w/Push-Button Start
50336: Off-road 6 Toggle switches/Dash Mount w/ Push-Button Start
Painless Performance Products recommends you, the installer, read this installation
manual from front to back before installing this harness.
Advertisement
Related Manuals for Painless Performance Products 50334
Summary of Contents for Painless Performance Products 50334
-
Page 1: Installation Instructions
Off-Road Switch Panel Installation Instructions 50334: Off-road 4 Toggle switches/Dash Mount w/Push-Button Start 50336: Off-road 6 Toggle switches/Dash Mount w/ Push-Button Start Painless Performance Products recommends you, the installer, read this installation manual from front to back before installing this harness. - Page 2 E-Mail: painless@painlessperformance.com If you have any questions concerning the installation of this product, feel free to call Painless Performance Products' tech line at 1-800-423- 9696. Calls are answered from 8am to 5pm central time, Monday thru Thursday, 8am-4:30pm Friday, except holidays.
- Page 3 CONTENTS OF THE PAINLESS KIT Refer to the Contents Figure (below) to take inventory. See that you have everything you’re intended to have in this kit. If you find that anything is missing or damaged, please contact the dealer where you obtained the kit or Painless Performance at (800) 423-9696.
-
Page 4: Installation
INSTALLATION First, decide what switches will be used for your application and install them into the panel. Start by adjusting the hex shaped backing nut on each of the switches ¾ of the way back toward the body of the switch. Insert the switch through the switch hole opening with the slot on the threads facing down and screw the black toggle switch boot onto the front of switch by hand until... - Page 5 Notice on the first switch to the left, from the start button, there is a red jumper from the circuit breaker directly below it for power. You will install the pink control wire with the doubled red wire onto the output of this switch. This short red wire will then be routed to the second circuit breaker to the left of the start button and the pink wire will be routed out to the ignition coil.
- Page 6 Individual wires with terminals on one end are the wires to be routed from the toggle switch to the device being controlled. The terminal end is for the switch and once the wire has been routed, the extra length may be cut off and then terminated. Each kit has one extra switch and one extra wire, which may be needed in your particular application.
- Page 7 Figure "C" illustrates the proper hookup of wires to an on/off switch, which will control a single device. Once all of the wires have been connected to the switches, the polyethylene liner can be installed. First decide where the wires will be exiting and make a small hole in the liner and pass the wires through the opening, then slide the liner over the switches and flush to the panel.
- Page 8 The illustrations below are some examples of typical relay installations. Electric Cooling Fan connection using Painless weatherproof relay kit #30130 Electric Fuel Pump connection using Painless weatherproof relay kit #30131...
- Page 9 Electric Water Pump connection using Painless weatherproof relay kit #30132 Painless Performance Products LLC Limited Warranty and Return Policy Chassis harnesses, fuel injection harnesses, and switch panel units are covered under a lifetime warranty. All other products manufactured and/or sold by Painless Performance are warranted to the original purchaser to be free from defects in material and workmanship under normal use.