Hatco METOS COMBI HOT 2L Installation And Operating Instructions Manual

Hatco METOS COMBI HOT 2L Installation And Operating Instructions Manual

Advertisement

Quick Links

MERCHANDISER
COMBI HOT-2L
Installation and operating instructions
12.2.2019
MG4252312

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the METOS COMBI HOT 2L and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Hatco METOS COMBI HOT 2L

  • Page 1 MERCHANDISER COMBI HOT-2L Installation and operating instructions 12.2.2019 MG4252312...
  • Page 2: Table Of Contents

    12.2.2019 METOS COMBI HOT 2L TABLE OF CONTENTS IMPORTANT SAFETY INFORMATION ......................3 Modellbeskrivning .............................4 Installation ..............................4 OPERATION ...............................6 4.1. Startup .................................6 MAINTENANCE ............................7 5.1. General ...............................7 5.2. Daily Cleaning .............................7 5.3. Replacing Display Light Bulbs ........................7 TROUBLESHOOTING GUIDE ........................8...
  • Page 3: Important Safety Information

    • Discontinue use if power cord is frayed or worn. • Do not attempt to repair or replace a damaged power cord. Cord must be replaced by Hatco, an Au- thorized Hatco Service Agent, or a person with similar qualifications.
  • Page 4: Modellbeskrivning

    12.2.2019 METOS COMBI HOT 2L NOTICE • Place the appliance on a flat, firm surface at a suitable working height. • Do not lay unit on the side with the control panel. Damage to unit could occur. • Use non-abrasive cleaners only. Abrasive cleaners could scratch the finish of the unit.
  • Page 5 12.2.2019 METOS COMBI HOT 2L Product divider rod NOTE. The picture is indicative and does not correspond to the current model Locator pin Channel divider 5. Install the channel dividers and product divider rods. NOTE: Unit must be transported in the upright position.
  • Page 6: Operation

    12.2.2019 METOS COMBI HOT 2L OPERATION Read all safety messages in the IMPORTANT SAFETY INFORMATION section before operating this equipment. Do not place food product directly onto hardcoat surface. Food product must be wrapped, boxed, or on a food pan.
  • Page 7: Maintenance

    12.2.2019 METOS COMBI HOT 2L MAINTENANCE 5.1. General The device is designed for maximum durability and performance with minimal maintenance ELECTRIC SHOCK HAZARD: STOP • Turn OFF power switch, unplug power cord, and allow unit to cool before performing any cleaning, setup, or maintenance.
  • Page 8: Troubleshooting Guide

    12.2.2019 METOS COMBI HOT 2L TROUBLESHOOTING GUIDE WARNING STOP This unit must be serviced by qualified personnel only. Service by unqualified personnel may lead to electric shock or burn. ELECTRIC SHOCK HAZARD: Turn OFF power switch, unplug power cord, and allow unit to cool before performing any cleaning, setup, or maintenance.
  • Page 9 12.2.2019 METOS COMBI HOT 2L...
  • Page 10 12.2.2019 METOS COMBI HOT 2L...
  • Page 11 EC Declaration of Conformity Date of Issue: September 2013 Hatco Corporation Hatco Corporation 635 S. 28 Street 1118 S. Neenah Ave. Milwaukee, W I 53215 Sturgeon Bay, W I 54235 Authorized representative located within the Community: Hatco Corporation C/O W illy Calluy, Legal Representative in Europe...

Table of Contents