Sony EZ77NZ Operating Instructions Manual page 12

Step 4: Tuning your TV to the VCR (continued)
5
6
RF CHANNEL
To obtain a clear picture from the VCR
If the picture does not appear clearly in step 5 above, press PROGRAM +/–
in step 5, so that another RF channel appears. Then tune the TV to the new
RF channel until a clear picture appears.
To set another RF channel number on the VCR, select a channel number that
does not receive a broadcast signal in your area and is clear of interference
from other channels.
If you cannot obtain a clear picture after performing this procedure, we
recommend you connect the VCR and TV using an audio/video cable (see
"To a TV that has audio/video input jacks" on pages 9 and 10). If the same
symptom persists, consult your nearest Sony dealer.
12
Getting Started
Tune the TV to the same channel as that
shown in the display window so that
the picture on the right appears on the
TV screen.
Refer to your TV manual for tuning
instructions.
If the picture does not appear clearly,
see "To obtain a clear picture from the
VCR" below.
Press RF CHANNEL.
You have now tuned your TV to the VCR. From now on, whenever
you want to play a tape, set the TV to the video channel.
SONY VIDEO CASSETTE
RECORDER