Sony DVCAM DSR-30P Operating Instructions Manual page 17

Setting the COMMAND MODE selector
Set COMMAND MODE on the remote commander to
the same position as that on the VCR (both switches are
set to "VTR4" at the factory.) Change the settings,
however, in the following cases:
• If you use two or more Sony VCRs: Change the setting
of each VCR in order to prevent accidental operation
caused by overlapping of commander signals.
• To control another Sony VCR with the remote
commander supplied with this VCR: Set COMMAND
MODE on the other VCR to the same position as that
on the remote commander supplied with this VCR.
• To control this VCR with the remote commander
supplied with the other Sony VCR: Set COMMAND
MODE on the remote commander supplied with the
other VCR to the same position as that on this VCR.
Tips
•If you set the COMMAND MODE on the operation panel to
"OFF," you can no longer control this VCR from any other Sony
remote commander.
• If the other Sony VCR does not have a COMMAND MODE
switch, use the following settings:
VTR 1: For Sony Betamax format VCRs
VTR 2: For Sony 8 mm format VCRs
VTR 3: For Sony VHS format VCRs
Note
Setting of the COMMAND MODE selector works on the
CONTROL S jack as well as the buttons on the remote
commander.
To change the settings of COMMAND MODE on
the remote commander
To change to VTR1 – VTR3
VTR
Set to the left.
To change to VTR4 – VTR6
VTR
Set to the right.
To change the settings of COMMAND MODE on
the VCR
To change to VTR1 – VTR3
Set to the left.
OFF
1 4
2 5
3 6
To change to VTR4 – VTR6
Set to the right.
OFF
1 4
2 5
3 6
Index to Parts and Controls
1 2 3
4 5 6
1 2 3
4 5 6
EN
17