Page 2
For more information please visit the website at www.recyclethis.info EN54 Part 17 Compliance TX7230 Isolator Module complies with the requirements of EN 54-17:2005. EN54 Standard Conformity Information 0832 TANDA(UK) LIMTIED...
Page 4
The TX7230 manufactured base on the requirement of EN 54 part 17, European Standard. In the event of short circuit on the detection loop the TX7230 Isolators either side of the loop will detect the problem and open circuit and isolates the faulty part of the loop, enabling other devises on the unaffected part of the loop to operate normally.
Page 5
TX7230 Isolator Module Installation & Operation Manual 2 Installation 2.1 Installation Preparation This interface module must be installed, commissioned and maintained by a qualified or factory trained service personnel. The installation must be installed in compliance with all local codes having a jurisdiction in your area or BS 5839 Part 1 and EN54.
Page 6
TX7230 Isolator Module Installation & Operation Manual 3 General Maintenance 1. Inform the suitable personnel before conducting the maintenance. Note: Since Isolator cannot disable from the control panel to prevent false alarm, it is recommended to temporarily close the loop once the isolator is removed.
Need help?
Do you have a question about the TX7230 and is the answer not in the manual?
Questions and answers