Nucamp T@B 320 Manual page 28

should burn off in a short time. Always follow the
appliance manufacturer's lighting and operating
instructions.
Read instructions before running. Please consult
the Norcold Refrigerator's Owner's Manual.
Leveling
Leveling is one of the requirements for proper
operation with refrigerators. Any time the vehicle is
parked for several hours with the refrigerator
operating, the vehicle should be comfortably
leveled to prevent loss of cooling. If the refrigerator
is operated when it is not level and the vehicle is not
moving, liquid ammonia will accumulate in sections
of the evaporator tubing. This will slow the
circulation or in severe cases completely block it,
resulting in a loss of cooling. When the vehicle is
moving, the rolling and pitching movement of the
vehicle will help to keep the liquid ammonia from
accumulating.
Propane Mode
This mode provides propane only. The control
system activates the ignition system and attempts to
light the burner for a period of approximately 45
seconds, at 2-minute intervals. To use the 3-Way
refrigerator on Propane Mode, if possible turn the
refrigerator on AC Mode or DC Mode for 15 to 20
minutes before lighting on propane, this will allow
the refrigerator to light easier. To light, turn the
selector switch to the flame symbol (propane) and
push in the red button (gas safety valve) until the
green light at the right side of the refrigerator comes
on. Hold the red button (gas safety valve) in for
about 30 seconds, DO NOT hold in for more than
30 seconds. When releasing the button, the green
light should stay on to indicate that the refrigerator
is on. If the refrigerator doesn't light or stay on,
contact your Dealer or Norcold. The battery must
have a decent charge before you can start the
refrigerator on propane mode.
NOTE: Do not travel
with your refrigerator
on propane as it may
blow out causing the
refrigerator to stop
cooling. When using
the refrigerator on
propane turn on the additional fan to help the
refrigerator cool. This will draw out the hot air
allowing the refrigerator to cool better.
AC Mode
To use the 3-Way refrigerator on AC Mode
(electric) turn the selector switch to the AC Electric
setting and adjust the dial to the desired
temperature. Turn the thermostat to the "5"
position. Allow the refrigerator to operate at this
setting for 6-8 hours before changing to the desired
temperature setting. If the refrigerator doesn't cool
check the breaker in the converter box and make
sure that the refrigerator cord is plugged into the
outlet in the cabinet next to the refrigerator under
the sink.
DC Mode
To use the 3-Way Refrigerator on DC Mode (12-
volt power), turn the selector switch to DC Mode
setting and adjust the dial to desired temperature. If
the refrigerator does not cool check the fuse located
in the converter box.
When DC mode is chosen, the refrigerator will
operate by pulling power from the battery/s. In most
cases, the refrigerator controls will continue to
operate when the battery is down to 9.6V DC,
causing a drain on the battery.
WHEN IN AUTO
MODE, IF THE REFRIGERATOR FAILS TO
OPERATE, REFER TO THE MANUFACTURER'S
USER MANUAL PROVIDED WITH THE NÜCAMP
.
RVOWNER'S PACKET
For more information, please consult the individual
owner's manual.
NOTE: DO NOT turn on DC mode unless you are
plugged into the tow vehicle and the tow vehicle is
running. Turn off the refrigerator before turning off
22