Cellular Select Gate Keypad Programming - Select Engineered Systems SG2CL Installer's Manual

Cellular Select Gate Keypad Programming
This is how to set a Cellular Select Gate keypad digit to dial a phone number; how to call a number; and
how to clear a number already assigned to a keypad digit.
Enter Programming Mode
Keypad Steps
* 0
Press and
together
Enter password digits
*
Press to end command
*0 7777 *
Example: { }
Assign Phone Number to Keypad Digit 1 K [phone number] *
Step
Enter command "1" then a sin-
gle keypad digit K (0 – 9)
Enter phone number
*
Press to end command
1 5 3058235410 *
Example:
Once programmed, press keypad digit, then Call button to call assigned Phone Number.
Clear a Keypad Digit Phone Number 1 K 0 *
Step
Enter command "1" then a sin-
gle keypad digit K (0 – 9)
Enter Clear command (0)
*
Press to end command
1 5 0 *
Example:
Exit Programming Mode
Step
Press exit characters together
Dialing Out
Factory Default se ngs: Touch tone 6 opens relay 1 for 1 second.
*0
{ }
*0
{ }
4 digits 0-9
*
Enters programming mode using factory default password 7777
Keypad
1 K
Up to 16
keys
*
Sets phone number 3058235410 to keypad digit 5
Keypad
1 K
0
*
Clears the phone number assigned to keypad digit 5
Keypad
*0
{ }
[4-digit password] *
Select Gate Response
2 beeps
Short beep for each key pressed
Password OK: 2 short beeps
Password NOT OK: long beep
Select Gate Response
Short beep for each key pressed
Short beep for each key pressed
Accepted:: 2 short beeps
NOT Accepted: long beep
Select Gate Response
Short beep for each key pressed
Short beep
Accepted: 2 short beeps
NOT Accepted: long beep
Select Gate Response
2 short beeps
6