Jolly X-5 Coupe User Manual page 6

Never let the power-cord come into contact with other cables! Handle the power cord and all connections
with particular caution!
Make sure that the available voltage is not higher than stated on the rearpanel.
Always plug in the power plug least. Make suer that the power-switch is set to off-position before you con
ections with themains with particular caution!
Make sure that the power-cord is never crimped or damaged by sharp edges.Check the decice and the p-
ower-cord from time to time.
Always disconnect from the mains, when the device is not in use or before cleaning it.
Only handle the power-cord by the plug,Never pull out the plug by tugging the powercord.
This device falls under protection class I.Therefore it is essential to connect the yellow/green conductor
to earth.
The electric connection,repairs and servicing must be carried out by a qualifids employee.
Do not connect this device to a dimmer pack.
Do not switch the fixture on and off in short intervals as this would reduce the lamp's life.rly mean that the
device is defective.
Do not touch the device's housing bare hands during its operation(housing becomes hot)!
For replacement use lamps and fuses of same type and rating only.
Caution! eyebamages!
Avoid looking directly into the light source(meant especially for epileptics)!
Minimum distance of illuminated objects
18
470W
The projector needs to be positioned so that the objects hit by the beam of light are at least
18 metres from the lens of the projector.
Maximum ambient temperature
° C
t 40
Do not operate the fixture if the ambient temperatuer(Ta) exceeds 40° C (104° F).
a
Temperature of the external surface
The maximum temperature that can be reached on the external surface of the fitting,in a ther-
° C
t 80
c
mally steadystate,is 80° C (176° F).
IP20 protection rating
The fitting is protected against penetration by solid of over 12mm (0.47" ) in diameter (first
IP20
digit 2), but not against dripping water,rain,splashes or jets of water (second digit 0).
Indoor use only
Not suitable for household illumination
Photobiological Safety
CAUTION. Do not look directly at the light source.Do not look at the light beam with optical de-
Risk Group 1
vices or any other tool that could cause light convergence.
According to
En62471
The fixture must be positioned so that the minimum distance between the front lens and human
eye is at least 3metres to prevent personal photobiological risks.
F
Mounting surfaces
It is permissible to mount the fitting on normally flammable surfaces.
The products to which this manual refers comply with the European Directives purs-
uant to:
•2006/95/EC - Safety of electrical equipment supplied at low voltage (LVD)
•2004/108/EC - Electromagnetic Compatibility (EMC)
•2011/65/EU - Restriction of the use of certain hazardous substances (RoHS)
•2009/125/EC - EcoDesign requirements for Energy-related Products (ErP)
Protection against electrical shock
Connection must be made to a power supply system fitted with efficient earthing (Class I app-
liance according to standard EN 60598-1) .It is, moreover, recommended to protect the supply
2