LINK-MI LM-SD104 User Manual

3g/hd/sd-sdi splitter 1 x 4

Table of Contents

Download this manual

Thank you for purchasing this product. For optimum performance and safety, please read these

instructions carefully before connecting, operating or adjusting this product. Please keep this manual for

future reference.

1×4 SDI splitter distributes allows 1 SDI, HD-SDI or 3G-SDI video source to 4 SDI/HD-SDI/3G-

SDI displays simultaneously. This

compatible with SD-SDI, HD-SDI, 3G-SDI all format of SDI signal. It is the support

2.97Gbps bandwidth, and supports lossless transmission over long distances.

3G/HD/SD-SDI Splitter 1 x 4 4 4

3G/HD/SD-SDI

User manual

VER:1.1

product

built-in

automatic

identification

and

Table of Contents

Do you have a question about the LM-SD104 and is the answer not in the manual?

Page 1: User Manual
3G/HD/SD-SDI Splitter 1 x 4 4 4 3G/HD/SD-SDI 3G/HD/SD-SDI User manual VER:1.1 VER:1.1 VER:1.1 Thank you for purchasing this product. For optimum performance and safety, please read these instructions carefully before connecting, operating or adjusting this product. Please keep this manual for future reference.
Page 2 1 SDI input signal split to 4 SDI sink devices. Supports SD-SDI(270Mb/s), HD-SDI(1.485Gb/s), 3G-SDI(2.97Gb/s) video format. Built-in cable equilibrium, clock recovery and drive. Supports resolutions up to 1920x1080@60Hz. Supports signal input and output distances of up to 300m for SD signals, 200m for HD signals and 100m for 3G signals.
Page 3 5. . . Operation controls and Fun n n ctions Front Panel ON/OFF: Power on/off switch. POWER LED: This red LED illuminate when the device is connected with power supply. POWER LED POWER LED LOCK LED: This red LED illuminate when the SDI signal plug in. LOCK LED LOCK LED Rear Panel...
Page 4 SDI INPUT SDI INPUT SDI INPUT: This slot is where you connect the SDI source output from SDI Camera. SDI OUTPUT PUT: These slots are where you connect the SDI displays or monitors with coaxial cable (RG6). DC 5V-12V 5V-12V 5V-12V: Plug the 5V or 12V DC power supply into the unit and connect the adapter to AC wall outlet.