Overview Of Video Tv Set Buttons; Inserting Batteries Into The Remote Control; Connecting The Aerial - Sony Trinitron KV-14FV1U Instruction Manual

Overview of Video TV Buttons
Tape transport buttons
(see page 10).
Main Power On/Off
switch
If you turn off the
Video TV by
using this button
and you do not
turn on it again
during 7 days, all
Headphone
the settings will
jack
be cleared.

Inserting Batteries into the Remote Control

Make sure to insert the supplied batteries using the correct polarities.
Always remember you dispose of used batteries in an environmental friendly way.

Connecting the Aerial

Connecting an Indoor aerial (for KV-14FV1U only)
For a better reception we recommend you connect an external aerial. However, if your
local UHF signal is strong, you can connect the supplied loop aerial as follows:
1 Insert the loop aerial into the holder on top of the Video TV until it clicks.
2 Connect the aerial connector to the aerial socket
3 After turning on the Video TV, adjust the aerial for optimum reception.
Connecting an Outdoor aerial
Connecting cables are not supplied.
Press on the mark
front of the Video TV to reveal
the front control panel.
Audio
Video
TIMER
Input Input
REC
jack jack
(recording)
on/off
button (see
page 13)
on the rear of the set.
TIMER REC
(recording)
DIAL TIMER
indicator (see
(see page 12)
page 13)
on the
Volume control buttons
Programme Up or Down
Buttons (Selects TV channels)
Selecting Input source
REC
(recording)
button (see
page 11)
REC (Recording)
button (see page11)
Standby on/off
Standby
button
indicator
By using this
button to turn off
the Video TV
instead of the Main
Power on/off
button, settings
will not be cleared
unless the power is
interrupted or you
disconnect the AC
power cord. In that
case settings will
be cleared after 7
days.
Overview-Installation
GB
5