Recording Tv Programmes Using The Timer - Sony Trinitron KV-14FV1U Instruction Manual

Recording TV Programmes Using the Timer

This function allows you to preset your Video TV to record up to 5 programmes
within a one-month period.
Before you begin:
• Make sure that the clock is set correctly. if it is not, please refer to the section "Setting
the Clock Manually"(see page 7).
• Make sure that the loaded cassette has its safety tab intact.
Setting the Timer
1
In standby mode, press the standby button
2
Press the TIMER REC button to display the Programme List menu.
3
Press or repeatedly to set the date (for daily and weekly recording, refer to the
section "Daily/Weekly Recording" below), then press
4
Proceed in the same way as in step 3 to set recording start time, recording stop time,
programme number, tape speed (SP or LP) and VPS/PDC "On" or "Off".
If you have made a mistake during timer setting, press
previous position and correct the setting.
• Date:
Daily/Weekly Recording
You can preset your Video TV to record the same programme every day of the
week (daily recording) or the same programme on the same day every week
(weekly recording).
Whilst you are in DATE position, with each press of
follows:
23 SAT (today) —> MON-SUN —> MON-SAT —> MON-FRI —> SAT (means
every Saturday...) —> FRI —> SUN —> 22 (next month).—>...
• Time:
• The hour increases or decreases by one hour.
• The minutes increase or decrease by one minute.
• Programme number:
• The programme position changes as follows:
0 <—> 1 <—> 2... <—> 99 <—> L1 <—> L 2 <—> 0 <—>1
• L1 is used for the equipment connected to the Scart connector :1/
rear of the Video TV.
• L2 is used for the equipment connected to the front connectors
• Tape Speed:
• In "LP" mode you can record twice as much as you can in "SP" mode
• VPS/PDC:
• For details refer to "Timer recording with VPS/PDC signals" section of this
instruction manual (see page 14).
5
Press OK.
6
If you want to set more programmes, press
then press OK. Repeat steps from 3 to 5.
7
After setting all your desired programmes press
the OK button to confirm your settings.
The TIMER REC indicator on the Video TV lights up and the Video TV enters into
timer recording standby mode.
To Stop Timer Recording
Press the ON/OFF button on the remote control, the TIMER REC indicator on the Video
TV turns off.
Using the Video TV before Timer Recording starts
You can watch a TV programme, check the timer settings and reset the counter in
timer recording standby mode. However, if you want to eject the cassette, use the
tape operation buttons, change or cancel the timer settings, you have to press the
ON/OFF button on the remote control to turn off the TIMER REC indicator on the
Video TV set.
Remember to press the ON/OFF button again to make the TIMER REC indicator
lights up. The set comes back into the timer recording standby mode.
to turn on the Video TV.
.
to return to the
, the setting changes as
and
...
or to move the cursor to ADD and
or and highlighting OK, press
Programme List
DATE START STOP PROG PDC
23 SAT 22:00
OK ADD CHANGE
on the
.
23 SAT 20:00
VPS
23:00 03 SP ON
CLEAR
OK
GB
13
VCR-Recording