Connecting The Ac Power Cord (Mains Lead); Setting Up The Sound Output Of The Connected Component - Sony 4-170-060-12(1) Operating Instructions Manual

Notes
• Be sure to fully extend the FM wire antenna (aerial).
• After connecting the FM wire antenna (aerial), keep it as horizontal as possible.
• Do not connect or disconnect the DIGITAL MEDIA PORT adapter while the stand is turned on.
• When you connect the DIGITAL MEDIA PORT adapter, be sure the connector is inserted with the arrow mark
facing toward the arrow mark on the DMPORT jack. To detach the DIGITAL MEDIA PORT adapter, press and
hold A and then pull out the connector.

Connecting the AC power cord (mains lead)

Before connecting the AC power cord (mains lead) of the stand to a wall outlet (mains), connect all the
other components and TV to the stand.
Note
• Connect the stand to an easily accessible AC outlet (mains). Should you notice an abnormality in the stand,
disconnect the main plug from the AC outlet (mains) immediately.

Setting up the sound output of the connected component

Depending on the audio output settings of the connected component, the sound may output in 2 channel
format only. In this case, set the connected component to output sound in multi-channel format (DTS,
Dolby Digital, multi-channel LPCM). For details on audio output settings, refer to the operating
instructions supplied with the connected component.
14
GB
A