Bodypack Transmitter - Electro-Voice R300 User Manual

2.3) Bodypack Transmitter

BP-300 CONTROLS, CONNECTORS AND INDICATORS
1) Antenna – Flexible ¼ wave antenna
2) Power On/Off/Mute Button
3
3) TA4 Microphone Connector
4) On/Mute LED – Green when transmitter is on, Red when muted
5) LCD Display
a. Channel
b. Frequency
c. Battery Level
d. Mute Indicator
6) EZsync infrared window
7) Battery Compartment Latch – push down latch and slide cover as shown.
8) Two AA Battery Compartment – follow polarity as marked
9) LAV/INS Gain Switch
2.3.1) Bodypack Transmitter Setup & Operation
1. Insert Batteries.
1.
down.
2.
3.
2. Turn the unit on by pressing and holding the on/off button for 3 seconds, and the LCD display will light
up. If channel has not been set, set channel according to 2.1.
3. Microphone/Guitar Operation.
1.
position.
2.
3.
the receiver is reaching the peak, put the gain switch in INS to lower the gain.
Preliminary Draft 01
Open the battery compartment by pressing in on the latch and sliding the door
Insert two AA batteries with + and – as indicated.
Close the battery door by pushing up.
For Lapel and Headworn Microphones the gain switch should be in the LAV
For Guitar operation the gain switch should be in the INS position.
If lapel or headworn microphones are too sensitive and the audio meter on
Page 9 of 14 5/6/2010