Electro-Voice R300 User Manual page 3

Quick Set-up: Receiver
1. Do not connect the receiver to any other equipment yet!
2. Connect the two Antennas to the receiver.
3.
Install the blades into the power supply, plug it into the back of the receiver, and into an outlet.
4. Press the POWER switch. Display will light up.
5.
Press and hold the ► button until CLEARSCAN scrolls across the screen.
6.
When CLEARSCAN stops, the receiver will be set to the clearest channel.
7. Turn the receiver off and connect the mixer or other audio system to the receiver XLR Connector or
the ¼ inch Line Level Jack.
8. Set the audio mixer or other system input level to minimum.
9. Press the Power switch button in again.
Receiver "Quick Set-up" is complete.
Quick set-up: Transmitter
1.
With the Power switch on the transmitter OFF, install two fresh AA batteries into the transmitter.
2.
Press the transmitter Power Switch until the display comes on.
3.
Hold the transmitter with the EZsync Port facing the receiver, about a foot (30cm) away.
4.
Press the SYNC Button on the receiver, SYNC will show in the display.
5. Once the channel is set in the transmitter, the display will switch to the main display and show RF
and Audio Levels.
Transmitter "Quick Set-up" is complete.
Quick set-up: System Operation
1. Set the mixer/amp gain.
2. Talk or sing into the microphone or play the guitar at a normal volume. You should hear audio coming
out of the system.
3.
You may have to adjust the gain (via the control next to the connector on the receiver back panel) to
provide the best input volume for your mixer/amp.
"Quick Set-up" is now complete. Please enjoy your R300 system.
Preliminary Draft 01 Page 3 of 14 5/6/2010