Vector G08 Series Faq page 27

CAP KIT SUMMARY:
There are some known problems with Zanen and Bob Roberts cap kits. Below is a recommended
list of parts. Almost all of the suggested replacement capacitors are upgraded in terms of voltage
rating and should make your G08 monitor last longer and run cooler. If you would like to make a
cap kit of your own, here are the suggested parts that you will need:
PCB Location
Deflection C401
Deflection C405
Deflection C406
Deflection C411
Deflection C601
Deflection C701
Input C800
Input C801
Input C802
Input C803
HV C900
HV C901
HV C904
HV C905
HV C911
HV C916
Note: some of the capacitor locations will differ slightly from the descriptions above, depending on
the deflection board revision you have. Generally speaking, you will be replacing all electrolytic
capacitors on the deflection and HV boards. If the list above states C405, it could be C407 on your
board. Make notes on what capacitors you remove, and replace those locations.
Capacitors C601 and C701 on the deflection board appear only on the schematics and are not listed
on the parts list of any manual. C601 and C701 are connected to pins 12 and 6 of IC600
respectively.
G08-003 Cap Kit Parts List
Part Description
1000uf 160V Radial Capacitor
10uf 50V Radial Capacitor
10uf 50V Radial Capacitor
22uf 350V Radial Capacitor
47uf 35V Radial Capacitor
47uf 35V Radial Capacitor
10uf 50V Radial Capacitor
10uf 50V Radial Capacitor
10uf 50V Radial Capacitor
10uf 50V Radial Capacitor
4.7uf 35V Radial Capacitor
4.7uf 35V Radial Capacitor
22uf 35V Radial Capacitor
22uf 35V Radial Capacitor
100uf 35V Radial Capacitor
47uf 200V Radial Capacitor
G08 Vector Monitor Guide
Upgrade Notes
Yes Original was 80V
Yes Original was 25V
Yes Original was 25V
Yes Original was 250V
Yes Original was 16V
Yes Original was 16V
Yes Original was 16V
Yes Original was 16V
Yes Original was 16V
Yes Original was 16V
Yes Original was 16V
Yes Original was 16V
Yes Original was 16V
Yes Original was 16V
Yes Original was 160V
Page 27 of 41