Specifications; Troubleshooting - Sony VTX-D800U Operating Manual

Digital terrestrial receiver
Hide thumbs Also See for VTX-D800U:
Table of Contents

Advertisement

Text.fm Page 21 Tuesday, April 27, 2004 8:21 AM

Specifications

Transmission standards
Channel coverage
TV scart
VCR scart
Audio output socket
Supply voltage
Power consumption
Operating temperature
Dimensions (W x H x D)
Weight
Accessories supplied
Design and specifications are subject to change without notice

Troubleshooting

Problem
The indicating light on the
front panel is not illuminated
The indicating light is Red
Remote control not working
You cannot find a channel
you have previously watched
No picture
Picture freeze
Picture and sound break up
No sound
Attention:
Picture distortion may occur if this unit is positioned in close proximity to any equipment emitting electromagnetic
radiation.
®
DVB-T
UHF channels B21 - B69
21 pin Euro connector (CENELEC standard) with SMARTLINK support
21 pin Euro connector (CENELEC standard) with SMARTLINK support
and synchro record
Digital optical output (PCM using a mini TOS lead) or analogue line-out
(2V RMS), 3.5mm jack socket
220 ~ 240V AC, 50Hz
10W (Maximum)
-10 to +40°C
215 x 48 x 240mm
1.5 Kg Approx.
1 Remote control RM-X800, 1 RF Loopthrough cable, 2
batteries, 1 Receiver stand,1 fully wired Scart lead
Possible cause
• Mains cable not connected
• The receiver is in standby
mode
• Batteries low
• The channel only broadcasts
for part of the day
• Scart plug loose
• Your TV might be unable to
switch automatically into the
AV mode
• Receiver malfunction
• Signal strength low (see page
14)
• Volume set too low on the TV
• TV in Mute mode
• Scart plug loose
Additional information
Solution
• Plug mains cable into power socket
• Press the l/1 button on the remote
control to cancel standby mode
• Replace both batteries
• Check the programme listings
• Check scart
plugs
are
connected
• Set the TV to AV mode e.g AV1 or
EXT1 etc. (refer to your TV
manual)
• Press and hold down the l/1
button on the front panel for 5
seconds then release and wait until
indicating light turns red. Press the
l/1 button on the remote control to
resume normal operation
• Check aerial installation
• Increase volume setting of your TV
• Cancel Mute mode
• Check scart plug connection
Additional information
AA size
firmly
21

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents