Get To Know The X103W Remote Controller - MJX R/C X103W User Manual

Battery installation
Before first flight charge the battery to make sure it is fully charged.
ALWAYS remove the battery from the drone to charge it.
Caution
: NEVER leave the battery charging unattended. Remove the battery from the charging cable
when the battery is fully charged – all 4 Blue lights are on.
Caution:
!
Get to Know Your X103W Remote Controller
Battery installation in the remote controller
1. Unfold the handles and open the battery compartment door (Pic. 1);
2. Install 2*AA batteries into the battery compartment and make sure they are in the correct polarity
(Pic. 2);
3. Close the battery compartment door (Pic. 3).
Pic. 1
● Insert batteries in the correct polarity: the transmitter requires 2*AA batteries.
!
● NEVER charge Non rechargeable batteries.
● NEVER mix old and new batteries.
● NEVER mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
● Rechargeable batteries MUST be removed from the drone before being charged.
● Rechargeable batteries should only be charged under adult supervision.
● Remove spent batteries from the drone and remote.
● NEVER short-circuit the battery terminals.
Make sure you press the battery into place firmly and hear the "click" when it
is locked. Try to pull the battery out to make sure it is properly installed. A loose
battery WILL cause the drone to malfunction and may cause damage to the
drone or to the person flying it or others in the vicinity.
Insert the battery into the battery
compartment in the top of the
drone body. Make sure you insert
the battery in the correct direction.
Press the battery into place firmly
until it locks on both sides. You will
hear a click once the locking tabs
are in place.
Pic. 2
-2-
X103W User Manual
Pic. 3