Aiwa Z-L30 Operating Instructions Manual page 17

u
8;10
In the programmed edit recording function the tracks can be
programmed while checking the remaining time on each side of
the tape as the tracks are programmed.
1
2
3
4
Insert the tape into Deck 1.
Insert the tape with the side to be recorded on first facing out
from the unit, and wind up the tape with +.
Press CD and load the disc(s).
Press CD EDIT/CHECK twice while pressing
SHIFT on the remote control.
"EDIT"
and "PRGM" are displayed.
PRGM EDIT
When "Al" is displayed, press CD EDIT/CHECK while
pressing SHIFT again.
Press numbered buttons on the remote control
to designate the tape length.
10 to 99 minutes can be specified.
.44, * or MULTI JOG are also available to designate
the tape length.
Tape length
Tape side A (front side)
Maximum recording
time for side A
5 Press one of DISC DIRECT PLAY 1-5 to select a
disc.
Then, press numbered buttons O-9 and +10 on
the remote control to program a track.
To select disc 4 or 5 from the remote control, press DISC
DIRECT PLAY 4 or 5 while pressing SHIFT.
Example: To select the 10th track of disc 2, press DISC
DIRECT PLAY 2, then press +10 and O.
Remaining
Programmed
Selected track number
time on side A track numbers
6
7
8
9
Prog;am number
Repeat step 5 for the rest of the tracks for side
A.
A track whose playing time is longer than the remaining time
cannot be programmed.
Press CD EDIT/CHECK while pressing SHIFT on
the remote control to select side B and program
the tracks for side B.
Tape side B (reverse side)
Press CD EDIT/CHECK while pressing SHIFT to
select side A and press . on Deck 1.
~
flashes for 10 seconds, and then CD play and recording
of edited tracks for the first side start simultaneously. When
the end of the tape is reached, Deck 1 enters the recording
stop mode. After entering the recording stop mode, go to
step 9.
Press CD EDIT/CHECK while pressing SHIFT on
the remote control for recording of the second
side.
"B is displayed.
10
Turn over the tape in Deck 1 and press@ to start
recording.
Recording starts.
To stop recording
Press /= on Deck 1. Recording and CD play stop
simultaneously.
To check the order of the programmed track numbers
Before recording, press CD EDIT/CHECK while pressing SHIFT
on the remote control to select side A or B, and press - or
- repeatedly.
Track number
Programmed track numbers
Disc number
Program number
To
change the program of each side
Press CD EDIT/CHECK while pressing SHIFT on the remote
control to select side A or B, and press CLEAR to clear the
program on the selected side. Then program tracks again.
To clear
the edit program
Press CLEAR twice in stop mode so that "EDIT" disappears
on the display.
Recording is inhibited if the erasure prevention tab for the side
of the tape facing out from the unit is broken off.
Up to 30 tracks can be programmed from any of the inserted
discs.
c "FULL" is displayed if you attempt to programme more than 30
tracks.
ENCWSH 17