Setting The Clock (Remote Control Only) - Sharp XL-DH259N Operation Manual

Listening to the radio (continued)
Presetting a station
You can store 40 AM and FM stations in memory and
recall them at the push of a button. (Preset tuning)
1
Perform steps 1 - 3 in "Tuning".
2
Press the MEMORY button.
3
Within 30 seconds, press the PRESET (
to select the preset channel number. Store the stations
in memory, in order, starting with preset channel 1.
4
Within 30 seconds, press the MEMORY button to store
that station in memory. If the "MEMORY" and preset
number indicators disappear before the station is
memorized, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a
preset station. When a new station is stored in the
memory, the station previously memorized for that
preset channel number will be erased.
Note:
The backup function protects the memorized stations for a
few hours should there be a power failure or the AC power
cord become disconnected.
To recall a preset station
Press the PRESET ( or
seconds to select the desired station.
To scan the preset stations
The stations saved in the memory can be scanned
automatically. (Preset memory scan)
1
Press the PRESET (
seconds. The preset number will flash and the
programmed stations will be tuned in sequentially, for 5
seconds each.
2
Press the PRESET (
desired station is located.
To erase entire preset memory
1
Press the ON/STAND-BY button to enter the stand-by
mode.
2
While pressing down the FUNCTION button, press the
POWER ON/STAND-BY button until "TUNER CLEAR"
appears.
or ) button
) button for less than 0.5
or ) button for more than 0.5
or ) button again when the
Setting the clock (Remote control
only)
In this example, the clock is set for the 12-hour (AM 12:00)
display.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CLOCK/TIMER button.
3
Within 10 seconds, press the MEMORY button.
Press the or
hour display and then press the MEMORY button.
"AM 12:00"
"AM 0:00"
"0:00"
4
To adjust the hour, press the
then press the MEMORY button. Press the
button once to advance the time by 1 hour. Hold it
down to advance continuously.
5
To adjust the minutes, press the
then press the MEMORY button. Press the
button once to advance the time by 1 minute.
To confirm the time display:
Press the CLOCK/TIMER button. The time display will
appear for about 5 seconds.
Note:
The "CLOCK" will appear or time will be displayed when
the AC power supply is restored after a power failure or
unplugging the unit. If incorrect, readjust the clock as
follows.
To readjust the clock:
Perform "Setting the clock" from step 1. If the "CLOCK"
does not appear in step 2, step 3 (for selecting the 12-hour
or 24-hour display) will be skipped.
To change the 12-hour or 24-hour display:
1
Clear all the programmed contents. [Refer to "Factory
reset, clearing all memory" on page 14 for details.]
2
Perform "Setting the clock" from step 1 onwards.
E-10
CD
USB
button to select 12-hour or 24-
The 12-hour display will appear.
(AM 12:00 - PM 11:59)
The 12-hour display will appear.
(AM 0:00 - PM 11:59)
The 24-hour display will appear.
(0:00 - 23:59)
or
or
button and
or
button and
or