Sony TA-N9000ES Operating Instructions Manual page 13

1
STANDBY
U
2 Operation indicators
Light to indicate the operation mode selected with the
OPERATION control. Blink if you select a mode that
cannot be used.
3 OPERATION control
Turn to select the channels you want to use.
When the OPERATION selector on the rear panel is
set to NORMAL
Position
2ch
3ch
4ch
5ch
EXTRA 2ch
Output Channels
FRONT (L/R)
FRONT (L/R) + CENTER
FRONT (L/R) + REAR (L/R)
FRONT (L/R) + CENTER +
REAR (L/R)
Signals input to the EXTRA 2ch
INPUT jacks are output from the
FRONT (L/R) speakers.
2
BTL 2ch BTL 2+1ch
2ch 3ch 4ch
When the OPERATION selector on the rear panel is
set to BTL
Position
BTL 2ch
BTL 2ch + 1ch*
BTL EXTRA 2ch
WARM UP
Set OPERATION to this position (instead of turning
the power off) to keep the circuitry warm when the
power amplifier is not being used. This enables you to
enjoy excellent sound quality immediately the next
time you use the power amplifier.
The warm up mode works the same during both
NORMAL and BTL operation.
* When OPERATION is in this position and a center speaker is
connected, the center speaker gain level drops about 6 dB. When this
happens, raise the level of the center speaker on the AV control
amplifier (TA-E9000ES, etc.) connected to this amplifier and adjust
the volume accordingly.
3
BTL EXTRA 2ch
5ch WARM UP EXTRA 2ch
OPERATION
WARM UP
5ch / BTL 2+1 ch EXTRA 2ch / BTL EXTRA 2ch
4ch / BTL 2ch
3ch
2ch
Output Channels
Signals input to the FRONT or
REAR INPUT jacks are output
from the FRONT (L/R) BTL
speaker connections.
Signals input to the FRONT or
REAR INPUT jacks are output
from the FRONT (L/R) BTL
speaker connections.
Signals input to the CENTER
INPUT jacks are output from the
CENTER SPEAKER jacks.
Signals input to the EXTRA 2ch
INPUT jacks are output from the
FRONT (L/R) BTL speaker
connections.
13 US