Sony TA-N511 Service Manual

TA-NOTI/N611
SERVICE MANUAL
Photo : TA-N511
US Model
TA-N511/N611
Canadian Model
E Model
Australian Model
TA-N511
SPECIFICATIONS
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
With 8-ohm loads, both channels driven,
from 20 - 20,000 Hz; rated 135 watts
(TA-N511) or 150 watts (TA-N611) per
channel minimum RMS power, with less
than 0.9% total harmonic distortion from
250 milliwatts to rated output.
Amplifier section
Power bandwidth (IHF)
7 Hz - 30 kHz (8 ohms)
Overall output (1 KHz, 8-ohm load)
TA-N511: 135 W + 135 W (front)
15 W + 15 W (rear)
TA-N611: 150 W + 150 W (front)
15 W + 15 W (rear/DRLC)
Harmonic distortion
TA-N511: Less than 0.9% (at 1 kHz, 8-ohm
load, front: 1385 W + 135 W, rear: off)
TA-N611: Less than 0.9% (at 1 kHz, 8-ohm
load, front: 150 W + 150 W, rear/DRLC: off)
Intermodulation (IM) distortion (60 Hz : 7 KHz)
Less than 0.9 % at rated output
Frequency response
INPUT (FRONT/REAR): 10 Hz - 70 kHz +3 dB
Input sensitivity 1 V (50 kohms)
Damping factor 40(8 ohms, 1 kHz)
Signal-to-noise ratio
115 dB
Output FRONT SPEAKER, REAR SPEAKER, and
DRLC SPEAKER (TA-N611 only):
Accepts speakers of 8 - 16 ohms.
HEADPHONES: Accepts low and high
impedance headphones.
General
Power requirements
TA-N511/N611: 120V AC, 6GOHz (US)
TA-N511: 120V AC, 6OHz (Canadian)
TA-N511: 220V AC, 50/60Hz (Australian)
TA-N511: 120V, 220V, 240V
Power consumption BR ROne HAE!
TA-N511: 230 W
TA-N611: 250 W
Dimensions Approx. 430 x 130 x 345 mm (w/h/d)
(17 x 5% x 133/, inches)
Weight TA-N511: Approx. 9.1 kg (20 Ib 1 02)
TA-N611: Approx. 10.0 kg (22 Ib 1 0z)
Design and specifications subject to change without notice.
STEREO POWER AMPLIFIER
SONY.