Cleaner Adjustments And Operation; Hose Length - Pentair Lil Rebel Installation And User Manual

To prolong the life of the 'Lil Rebel™ Aboveground Suction-Side Pool Cleaner, the cleaner
should be removed from the pool before any pool chemical treatment. Failure to do so
can result in discoloration of the cleaner and deterioration of cleaner components.
After installation, turn the pool pump on. The cleaner should be moving about the pool at a rate of 22 to 30 feet
per minute. Be sure to check each of the following initial adjustments.

Hose Length

Note: The pump must be on when you check the hose length. The hose contracts when the pump is operating and
will be longer when the pump is off. Do not remove the cleaner from the pool while it is operating.
While the cleaner is operating:
1. Position cleaner at the furthest point of the pool from where it's attached. Use a pool pole and brush to easily
position the cleaner in the pool.
2. The hose should be long enough to reach the end of the pool, plus one hose section and the leader hose. See
Figure 9.
3. Remove any excess hose lengths from the middle of the hose assembly. This will ensure you do not alter the
position of the hose float.
4. Save extra hose sections for use as needed for replacement.
Note: Turn pool pump off when adding or removing hose sections.

CLEANER ADJUSTMENTS AND OPERATION

'LIL REBEL™ Aboveground Suction-Side Pool Cleaner Installation and User's Guide
Figure 9
5