Changing The Display - Sony STR-DB895D Operating Instructions Manual

Changing the display

Changing the information in
the display
You can check the sound field etc. by changing
the information in the display.
Press DISPLAY repeatedly.
Each time you press DISPLAY, the display will
change cyclically as follows:
Index name of the input
Sound field currently applied t Volume level
When tuning in an FM/AM band
b)
Program Service name
a)
t Frequency t Program Type
preset station
b)
t Radio Text indication
indication
Current Time indication (in 24-hour system)
t Sound field currently applied t
Volume level
When tuning in a DAB station
Service Component Label t Frequency t
Program Type indication t Dynamic label
segment t Current Time indication (in 24-hour
c)
t Channel label t Audio Info
system)
e)
Signal Quality t Sound field currently
applied t Volume level
a)
Index name appears only when you have assigned
one to the input or preset station (page 47). Index
name does not appear when only blank spaces have
been entered, or it is the same as the input name.
b)
During RDS reception only (page 29).
c)
Time information appearing in the display is sent by
the DAB station. As a result, the time may not be
displayed properly if the station is located in a
different time zone.
"– –H – –M" is displayed until the time information
is received.
d)
Audio information on bit rate (32kbps - 256kbps),
signal type (stereo, dual, mono) and sampling type
(F: 48kHz, H: 24kHz) is displayed.
Example: 128K S F
e)
The DAB station sound quality is displayed.
"Q. _ _ _" is displayed until the sound quality
information is received.
Note
When "STEREO" appears in the display, the current
programme is broadcasted in the stereo/joint
(intensity) stereo mode.
a)
t Selected input t
or index name of the
b)
t
b)
d)
t
31 GB