1. Manuals
  2. Brands
  3. Flame Manuals
  4. Control Unit
  5. DUALKEY EURO MODUL
  6. Manual

Flame DUALKEY EURO MODUL Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
FLAME
DUALKEY EURO MODUL
MANUAL
Version 1.00

Advertisement

Table of Contents
loading

Related Manuals for Flame DUALKEY EURO MODUL

Summary of Contents for Flame DUALKEY EURO MODUL

  • Page 1 FLAME DUALKEY EURO MODUL MANUAL Version 1.00...

  • Page 2: Table Of Contents

    Manual FLAME DUALKEY MODULE Version 1.00 Contents 1. Short description ............... 3 2. Hardware / Connection .............. 3 2.1 Module overview 2.2 Connection 3. Play Modi ................... 5 3.1 Mode ONE SHOT 3.2 Mode GATE 3.3 Mode LOOP 4. Parameter .................. 6 4.1 SHAPE (shape of envelope)

  • Page 3: Short Description

    1. Short description Dualkey is composed of two modulators with A(H)D, A(S)R and Loop modes. Length and shape of rising / falling edge can be adjusted manually as well as influenced by CV signals. At most, the module emits voltages of 0..+10v. Additionally the circuits generate a trigger signal after each envelope cycle.

  • Page 4: Connection

    2.2. Connection to the modular system (Doepfer Bus) The module is delivered with a connected ribbon cable for the Doepfer bus. The red lead marks -12 volt. Connecting the module please note the right polarity! If the module is poled accidentally wrong safety diodes avoid the immediate destruction of the module but further damages cannot be excepted.

  • Page 5: Play Modi

    3. PLAY MODI 3.1. Mode ONE SHOT Keypress (or Trigger via KEY input) starts the envelope (voltage via CV output jack). The enve- lope plays only one-time and create after the end a short trigger impuls via the END output jack. Reset the envelope, if you press again the key and while still play the envelope (Retrigger).

  • Page 6: Mode Loop

    3.3. Mode LOOP Play the evelopes in loop while hold down the key (or high level via KEY input). Each envelope create after the end a short trigger impuls via the END output jack. Set the lenght of the enve- lopes with POT TIME, set the shape with POT SHAPE and set the output level with POT LEVEL.

  • Page 7: Time (Duration Of Envelope)

    4.2. TIME (duration of envelope) POT TIME set the duration of the envelope. There are three ranges between 1ms..1min, selec- table with the TIME range switch . If you use the TIME CV input, then the POT is an attenuator of the CV input.
  • Page 8 - electric damage caused by improper connecting (wrong power supply/ jacks/ MIDI connections/ voltage problems). If you have any complaints please contact your dealer or send an e-mail to: service@flame.fortschritt-musik.de 5.3 Terms of production conformity: CE, RoHS, UL 5.4 Disposal The device is produced with RoHS-conformity (subject to the regulations of the European Union) and is free of hazardous substances (like mercury, plumb, cadmium and hexavalent chrome).

Table of Contents