Setup
Install
The magDomus device is intended to be connected to a main power supply, to a communication
network and to one or more home automation networks.
1. Connect the device to the main power supply using the provided transformer and power cord.
Verify that the transformer is compatible in form factor and in electrical specification to the available
power mains standardized in your country. In case of incompatibility please contact your local
magnocomp supplier for a solution.
Fig. 4. Power supply transformer (example)
2. Connect the device to your local Ethernet network using the provided UTP cable with RJ-45
connectors.
Fig. 5. UTP cable with RJ45 connectors
One cable's end should be connected to the Ethernet port of your magDomus device. The other end
can be connect to any RJ-45 socket from your local network or to an available port in any active