B&S Commercial Kitchens CCF-HP Installation, Operating And Servicing Instruction Manual page 11


B&S recommends that this appliance is inspected at least annually by a authorised service
technician as follows:
o
Inspect the table inside-out for excessive build-up of any fats, oils and foodstuffs.
o
Inspect that the burners and other components (i.e. pilots, thermocouples, etc.) are in good
condition and functioning properly.
o
Inspect all gas connections for leaks and ensure all connections are tightened properly.
o
Ensure burner manifold pressure is in accordance with that specified on the data plate of the
appliance.
o
Inspect all gas connections for leaks and ensure all connections are tightened properly.
In case of difficulties, contact B&S Commercial Kitchens Pty Ltd or their authorised service agent.
.
Servicing Instructions


FAILURE TO DO SO WILL VOID B&S WARRANTY AND MAY RESULT IN DAMAGE TO EQUIPMENT
Removal of Front Panel
1. To remove the front panel.
2. Loosen the lock nut and remove the control arm.
3. Undo the screws holding the panel to the front of the appliance.
4. Be careful not to put pressure on any wires as the control panel is fixed to the front panel.
5. It is not necessary to remove any side or rear panels to service this appliance.
Replacement of The Combination Control
1. In case of combination control mal function it should be replaced with a new control of identical
model to the control fitted to this appliance.
2. Turn off the main gas valve.
3. Remove the front panel.
4. The combination control is mounted on a bracket on the left hand side behind the front cover.
5. Disconnect the gas pipes on either side of the control.
6. Disconnect the pilot tube connection.
7. Disconnect the wire connections.
8. Undo the bracket screws and lift the valve out.
9. Reassembly is in reverse order.
Replacement of The Single Solenoid Valve
1. This valve should be replaced with a new valve of identical model to the one fitted to the appliance.
2. Turn off the main gas valve.
3. Remove the front panel.
4. This valve is mounted directly below the combination control.
5. Disconnect the gas pipes on either side of the valve.
6. Disconnect the wire connections.
7. Lift the valve out.
WARNING!
Servicing shall be carried out by autorised personnel only. Failure to do so will void
the B&S warranty and may result in damage to equipment or injury to personnel.
Before commencing any disassembly/ assembly of gas controls, please ensure the
gas supply is turned off (isolated).
OR INJURY TO PERSONNEL.
11