Changing The Recorded Level After Recording (S.f Edit Function) - Sony MXD-D5C Operating Instructions Manual

Editing Recorded MDs
3
Press AMS or YES.
One of the following messages appears in the
display, depending on the type of editing to be
undone:
Editing done
Erasing a single track
Erasing all tracks on an MD
Erasing a part of a track
Dividing a track
Combining tracks
Moving a track
Labeling a track or an MD
Copying a title
Changing an existing title
Erasing a title
Erasing all titles on an MD
4
Press AMS or YES again.
"Complete!" appears for a few seconds and the
contents of the MD are restored to the condition
that existed before the edit.
To cancel the Undo Function
Press MENU/NO or p.
38
Message
"Erase Undo?"
"DivideUndo?"
"CombinUndo?"
"Move Undo?"
"Name Undo?"
Changing the Recorded Level
After Recording
(S.F Edit Function)
You can change the volume of recorded tracks using
S.F (Scale Factor) Edit. The original track is recorded
over at the new recording level. When changing the
recording level, you can select Fade-in Recording to
gradually increase the signal level at the start of
recording, or Fade-out Recording to gradually decrease
the signal level at the end of recording.
MENU/NO
Changing the overall recording level
1
While the deck is stopped, press MENU/NO to
display "Edit Menu."
2
Turn AMS to select "S.F EDIT?", then press AMS
or YES.
3
Turn AMS to select "Tr Level?", then press AMS
or YES.
4
Turn AMS until the track number you want to
change the recording level appears in the display,
then press AMS or YES.
"Level 0dB" appears in the display.
5
While monitoring the sound, turn AMS to change
the recorded level so that the OVER indication
(red) of the peak level meters does not turn on.
You can set the level at any value between –12 dB
and +12 dB, in 2 dB increments.
OVER indication
YES
AMS