Typical Connections - Quanser AMPAQ-PWM User Manual

Cable
(f) Analog Cable
(g) Digital I/O Cable
(h) Split Digital I/O Cable
Table 5.1: Cables used to connect the AMPAQ-PWM to a Quanser DAQ and experiment

5.2 Typical Connections

Refer to the experiment-specific User Manual and Laboratory Guide for wiring instructions.
AMPAQ-PWM User Manual
Type Description
6-pin-mini-DIN to This cable connects an external analog sensor to the
6-pin-mini-DIN AMPAQ-PWM S1, S2, S3, or S4 Analog Sensor input.
The cable also supplies ± 12 VDC from the AMPAQ-
PWM to power the sensor.
16-pin Ribbon Ca- This cable connects the Digital I/O connector on the
ble AMPAQ-PWM to a Q2-USB or QPIDe terminal board.
Split 16-pin Ribbon This cable connects the Digital I/O connector on the
Cable AMPAQ-PWM to a Q8-USB.
DRAFT - August 15, 2016