Setting The Clock - Sony MJ-L1 MJ-L1A Operating Instructions Manual

Setting the Clock

The built-in clock shows the time in the
display even when the power is off.
Use the buttons on the unit for this
operation.
1
3,5 2,4
1
Press CLOCK.
2
Set the current hour by turning the JOG
dial until the correct hour appears.
flashing
3
Press ENTER/YES.
The minute indication begins flashing.
flashing
4
Set the current minute by turning the
JOG dial until the correct minute
appears.
flashing
5
Press ENTER/YES.
The clock starts running and the upper
dot flashes. Use the time signal to set the
clock accurately.
The upper dot flashes for the first half of
a minute (0 to 29 seconds), and the
lower dot flashes for the last half of a
minute (30 to 59 seconds).
flashing
6 Chapter 1: Setting Up
To check the time while power is on
Press CLOCK.
The current time is displayed for 4 seconds.
To correct the clock setting
With the power turned off, repeat steps 1
through 5.
With the power turned on, press CLOCK
twice and repeat steps 2 through 5.