Timer-Recording Radio Programmes - Sony MJ-L1 MJ-L1A Operating Instructions Manual

2 Press ENTER/YES.
The minutes digits flash in the
display.
CD MD
VOLUME
DAILY
flashing
3 Use the JOG dial to set the minutes.
CD MD
VOLUME
DAILY
flashing
4 Press ENTER/YES.
"OFF" appears and the hour digits
flash in the display.
CD MD
VOLUME
DAILY
flashing
6
Set the time you want the system to turn
off in the same way.
7
Use the JOG dial to select a sound
source.
The display changes as follows:
n CD PLAY ˜ TUNER
n M D P L A Y N
8
Press ENTER/YES.
The preset items appear in the display
sequentially.
9
Press POWER to turn off the system.
About 15 seconds before the preset time,
the power will go on at the preset time
and the music will play. At the turn-off
time, the power will go off again.
To cancel the timer
Press TIMER SELECT repeatedly until
"TIMER OFF" appears in the display.
To change the timer
Repeat all above procedure from step 1.
You can check the preset items
Press TIMER SELECT repeatedly until
"DAILY" appears in the display again.
Preset items appear in the display.
Timer-Recording
Radio Programmes
You can set the timer to record from the
radio at a certain time. This timer works
only once for each setting. The volume level
is automatically set to MIN.
If you record from a preset station you have
assigned a name, the name, on time and off
time are stored on the MD automatically.
•Preset the station you want to record.
•Make sure the clock has been set correctly.
POWER m ON
TIMER
2
SELECT
3,4,5,6
1
Tune the preset station you want to
N
record.
2
Press TIMER SET repeatedly until the
"REC TIMER ?" appears in the display.
3
Press ENTER/YES.
"REC" appears and hour digits flash in
the display.
REC
4
Set the time you want the system to
start recording.
1 Use the JOG dial to set the hour.
REC
2 Press ENTER/YES.
The minutes digits flash in the
display.
REC
,8
4,5
VOLUME
flashing
VOLUME
flashing
MD
VOLUME
flashing
3 Use the JOG dial to set the minutes.
VOLUME
REC
flashing
4 Press ENTER/YES.
"OFF" appears and the hour digits
flash in the display.
VOLUME
REC
flashing
5
Set the time you want the system to turn
off in the same way.
6
Press ENTER/YES.
The preset items appear in the display
sequentially.
7
Insert a recordable MD.
"TOC Reading" appears in the display
for a few seconds and the MD deck
reads the contents of the MD.
8
After "TOC Reading" disappears from
the display, press POWER to turn off the
system.
About 15 seconds before the preset time,
the power turns on and the volume level
is automatically set to the MIN.
Notes
•Do not turn off the power while "TOC
Reading" appears in the display. The
timer operation may not be performed
correctly.
•If you use a brand new MD, nothing is
recorded for the first 15 seconds.
To cancel the timer
Press TIMER SELECT repeatedly until
"TIMER OFF" appears in the display.
To change the timer
Repeat all above procedure from step 1.
You can check the preset items
Press TIMER SELECT repeatedly until
"REC" appears in the display again. Preset
items appear in the display.
Chapter 8: Additional Features
27