Sony MHC-VX55 Operating Instructions Manual page 6

Step 1: Hooking up the system
(continued)
7
Follow the instructions below to set
the color system according to your
TV. The factory setting is AUTO.
Make sure the power is off each
time before setting the color system.
After you set the color system, the
power turns on automatically and
the function is set to CD.
If your TV automatically changes the
color system according to the input
signal:
Press ?/1 while holding down X. The color
system is set to AUTO.
AUTO automatically changes the color
system of the video output according to the
color system of the current VIDEO CD.
If the color system of your TV is NTSC:
P
ress ?/1 while holding down >. The color
system is set to NTSC.
If the color system of your TV is PAL:
P
ress ?/1 while holding down .. The color
system is set to PAL.
Note
When you set color system to NTSC and play back a
VIDEO CD recorded in the PAL color system, the
picture image may be distorted depending on the
disc. Similarly, when you set color system to PAL
and play back a VIDEO CD recorded in the NTSC
color system, the picture image may be distorted
depending on the disc.
To connect optional components
See page 46.
To deactivate the demonstration
When you set the time (see "Step 2: Setting
the time"), the demonstration is deactivated.
To activate/deactivate the demonstration
again, press DISPLAY while the system is off.
6
To attach the front speaker pads
Attach the supplied front speaker pads to the
bottom of the speakers to stabilize the
speakers and prevent them from slipping.
Positioning the speakers
(MHC-VX77 only)
Before you connect them, determine the best
location for your speakers.
1
Place the front speakers at an angle
of 45 degrees from your listening
position.
Front
speaker
(L)
Surround
speaker
(L)
2
Place the surround speakers facing
each other at about 60 to 90 cm
above your listening position.
60 to 90 cm
Front
speaker
(R)
45º
Surround
speaker
(R)
Surround
speaker