Specifications - Sony MHC-NXM1 Operating Instructions Manual

To save a tape permanently
To prevent a tape from being accidentally recorded
over, break off the cassette tab from side A or B as
illustrated.
If you later want to reuse the tape for recording, cover
the broken tab with adhesive tape.
Before placing a cassette in the tape
deck
Take up any slack in the tape. Otherwise, the tape may
get entangled in the parts of the tape deck and become
damaged.
When using a tape longer than
90 minutes
The tape is very elastic. Do not change the tape
operations such as play, stop, and fast-winding
frequently. The tape may get entangled in the tape
deck.
Cleaning the tape heads
Clean the tape heads after every 10 hours of use.
Be sure to clean the tape heads before you start an
important recording or after playing an old tape.
Use a separately sold dry-type or wet-type cleaning
cassette. For details, refer to the instructions of the
cleaning cassette.
Demagnetizing the tape heads
Demagnetize the tape heads and the metal parts that
have contact with the tape after every 20 to 30 hours of
use with a separately sold demagnetizing cassette. For
details, refer to the instructions of the demagnetizing
cassette.
32 GB
Break off the
cassette tab

Specifications

Main unit
Amplifier section
The following measured at AC 120 – 127/220 – 240 V,
50/60 Hz (Saudi Arabian model only)
The following measured at AC 230 V, 50/60 Hz
(European and Russian models only)
The following measured at AC 120/220 – 240 V,
50/60 Hz (except for European, Russian and Saudi
Arabian models)
The following measured at AC 220 V, 60 Hz
(Korean model only)
MHC-NXM1
DIN power output (rated): 55 + 55 watts
Continuous RMS power output (reference):
MHC-NXM3
DIN power output (rated): 75 + 75 watts
Continuous RMS power output (reference):
(6 ohms at 1 kHz, DIN)
75 + 75 watts
(6 ohms at 1 kHz, 10%
THD)
(4 ohms at 1 kHz, DIN)
100 + 100 watts
(4 ohms at 1 kHz, 10%
THD)