Timer Recording Radio Programs; Rec Timer - Sony MHC-NXM1 Operating Instructions Manual

Timer recording radio
programs

— Rec Timer

You can record a preset radio station from a
specified time.
To timer record, you must first preset the radio
station (see "Presetting radio stations" on
page 12) and set the clock (see "Setting the
clock" on page 8).
Use buttons on the remote for the operation.
1
Tune in the preset radio station (see
"Listening to a preset station" on
page 14).
2
Press CLOCK/TIMER SET.
"PLAY SET?" appears.
3
.
Press
"REC SET?", then press ENTER.
"ON" appears and the hour indication
flashes.
4
Set the time to start recording.
Press . or > repeatedly to set the
hour, then press ENTER.
The minute indication flashes.
Press . or > repeatedly to set the
minute, then press ENTER.
5
Set the time to stop recording following
the same procedure as step 4.
The start time, the stop time, and the preset
radio station to be recorded (e.g., "TUNER
FM 5") appear in turn, before the original
display returns.
6
Load a recordable tape into deck B.
7
Press TAPE to switch the function to
TAPE.
8
Press PLAY MODE repeatedly until g
appears to record on one side or h (or
j) to record on both sides.
22 GB
or > repeatedly to select
9
Press nN on the unit repeatedly to
select recording side.
If you select both sides recording or front
side recording, press nN to light up the
>>> indicator. If you record on the reverse
side, press nN again to light up the <<<
indicator.
10
Press ?/1 to turn off the system.
Other operations
To Do this
1
Check the setting Press CLOCK/TIMER
SELECT.
Press . or >
2
repeatedly until "REC
SELECT?" appears, then
press ENTER.
Change the setting Start over from step 1.
1
Cancel the timer Press CLOCK/TIMER
SELECT.
Press . or >
2
repeatedly until "TIMER
OFF?" appears, then press
ENTER.
Notes
• You cannot activate the Play Timer and the Rec
Timer at the same time.
• If you use the the Rec Timer and the Sleep Timer at
the same time, the Sleep Timer has priority.
• Do not operate the system from the time the system
turns on until the recording starts (about 15 seconds
before the preset time).
• If the system is on about 15 seconds before the preset
time, the Rec Timer will not be activated.
• The volume is reduced to minimum during
recording.