Table of Contents
Advertisement
SECTION 3: INSTALLATION
Club Chair V2
THE FOLLOWING TECHNICAL DIAGRAMS SHOULD BE GIVEN TO YOUR ENGINEERS,
ARCHITECTS, DESIGNERS, ELECTRICIANS & PLUMBERS.
Failure to comply with federal, state, or local codes and ordinances could result in the
voiding of product warranty as well as potential injury and flooding. A licensed plumber
should make all utility connections. All plumbing connections must conform to local
codes. Water temperature/pressure should not exceed local regulations.
The following footprint establishes the MINIMUM recommendations.
• Note: The floor has to be capable of supporting the expected load - minimum 200 lbs.
• Note: If your chair has back tilt, a minimum of 12" should be between the wall and the back of the
chair when upright which will allow the chair to tilt back to its farthest point.
• Note: The soaking tub will not have the hydrotherapy jets installed. Plumbing and electrical
connections are the same.
Wall
12"
6
76.5"
66.25"
38.5"
50.5"
wall to end of tub
wall to center of drain
15.75"
center of drain
Advertisement
Table of Contents
