Table of Contents
Advertisement
Option 2 - Plumbed to the Floor
•
Use this opti on if your hot and cold water supply and drain line will be located in the
fl oor underneath the tub. For this opti on, a licensed plumber will need to disconnect the
internal connecti ons from the manifold and re-route the lines as needed.
•
Release power cord from the strain relief (if needed) to be plug into a fl oor outlet.
•
Before installati on, carefully review the diagrams and specifi cati ons on pages 18-24 to
ensure all spacing and placement is correct.
•
All CAD symbols are for representati on only. Correct connecti ons are responsibility
of the purchaser, owner and/or its agents, installers, and should only be completed
by licensed professionals. Living Earth Craft s is not responsible for any incorrectly
interpreted, owner-installed water or electrical connecti ons.
Tub - Top View
If using a fl oor drain, locate within the
NOTE: Floor drain should be no larger than 8" x 8" (larger drains could protrude from the
bott om of the tub footprint).
Supply line should be taken into account prior to placement. The supply line area is shown
with the
green shaded area
to clear the tub.
26"
SECTION 3: INSTALLATION
red shaded area
in the diagram on the left . Supply lines need to be short enough
15"
7" from drain center
14"
14"
4"x 6"
22"
shown in the diagram below.
7" from drain center
13
Advertisement
Table of Contents
