Location Safety - Samsung NY36R9966P Installation Manual

Important safety information
• Make sure your range is correctly installed and adjusted by a qualified service
technician or installer for the type of gas (natural or LP) you will use. For
your range to utilize LP gas. The installer must replace the 6 surface burner
orifices with the provided LP orifice set. And reverse the GPR adapter. These
adjustments must be made by a qualified service technician in accordance
with the manufacturer's instructions and all codes and requirements of the
authority having jurisdiction. The qualified agency performing this work
assumes the gas conversion responsibility.
• Installation of this range must conform with local codes or, in the absence of
local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA.54, latest
edition. In Canada, installation must conform with the current Natural Gas
Installation Code, CAN/CGA-B149.1, or the current Propane Installation Code,
CAN/CGA-B149.2, and with local codes where applicable. This range has been
design-certified by ETL according to ANSI Z21.1, latest edition, and Canadian
Gas Association according to CAN/CGA-1.1, latest edition.
8 English
Install_NY9900R_CHEF_NY36R9966PS_AA_DG68-01106B-01_EN+MES+CFR.indb 8

Location safety

WARNING
To reduce the risk of fire, electric shock, personal injuries, and/or death, obey the
following precautions.
•
•
• Select a level, well-constructed floor that can support the range's weight.
Synthetic flooring, such as linoleum, must withstand 180 °F (82 °C)
temperatures without shrinking, warping, or discoloring. Do not install
the range directly over interior kitchen carpeting unless a sheet of ¼ inch
plywood or a similar insulator is placed between the range and carpeting.
• Select a location where a grounded, 3- prong outlet is easily accessible.
• If the range is located near a window, do not hang long curtains or paper
blinds on that window.
• For the range to ventilate properly, make sure the range's vents are not
blocked or covered, and that there is enough clearance at the top, back, sides,
and underneath the range. The vents allow the necessary exhaust for the range
to operate properly with correct combustion and get the good cooking result.
• Make sure the wall coverings around the range can withstand heat up to
194 °F (90 °C) generated by the range.
• Cabinet storage above the surface of the range should be avoided. If cabinet
storage above the range is necessary: allow a minimum clearance of 30 inches
(76.2 cm) between the cooking surface and the bottom of cabinets. For detail
information, please refer to the Minimum dimensions section on page 14.
This range is for indoor, household use
only. Do not install the range in areas
exposed to the weather and/or water.
Do not install the range in a place
which is exposed to a strong draft.
2019-03-14 3:55:50