Functional Description - Makita 6823 Instruction Manual

FUNCTIONAL
DESCRIPTION
1
A
B
1. Locking sleeve
1mm
1. Locator
1mm
1. Locator
1
1. Switch trigger
2. Lock button
CAUTION:
• Always be sure that the tool is switched off and unplugged before
adjusting or checking function on the tool.
Depth adjustment
002612
The depth can be adjusted by turning the locking sleeve. Turn it in "A" direction
for less depth and in "B" direction for more depth. One full turn of the locking
sleeve equals 1.5 mm change in depth.
Adjust the locking sleeve so that the distance between the tip of the locator
004149
and the screw head is approximately 1 mm as shown in the figures. Drive a
trial screw into your material or a piece of duplicate material. If the depth is still
1
not suitable for the screw, continue adjusting until you obtain the proper depth
setting.
004154
1
Switch action
002628
CAUTION:
• Before plugging in the tool, always check to see that the switch trigger
actuates properly and returns to the "OFF" position when released.
2
To start the tool, simply pull the switch trigger. Tool speed is increased by
increasing pressure on the switch trigger. Release the switch trigger to stop.
For continuous operation, pull the switch trigger and then push in the lock but-
ton.
To stop the tool from the locked position, pull the switch trigger fully, then
release it.
NOTE:
• Even with the switch on and motor running, the bit will not rotate until you
fit the point of the bit in the screw head and apply forward pressure to
engage the clutch.
5