Naming A Track Or Md (Name) - Sony MDS-JE440 Operating Instructions Manual

Naming a track or MD
(NAME)
You can enter a name for a recorded MD as well as for
individual tracks. Names can consist of uppercase and
lowercase letters, numbers, and symbols. A total number
of about 1,700 characters can be stored for all the names
on the MD.
AMS
Z
Letter/number
buttons
. >
H
z
./>
. >
m/M
m M
Note
If you name a track while it is being recorded, be sure to finish
the naming operation before the track ends. If the track ends
before you finish, the entered character data will be discarded
and the track will remain unnamed. Also, you cannot name
tracks while the deck is recording over existing material.
Naming a track or an MD using the
controls on the deck
1
Press MENU/NO while the deck is in one of the
operating modes listed below, depending on what
you want to name:
To name
A track or the MD
The track being recorded
"Edit Menu" appears in the display.
To enter a name while the deck is recording, go to step
3.
2
Turn AMS until "Name ?" appears, then press AMS
or YES.
MENU/NO YES m/M
AMS
LEVEL/DISPLAY/CHAR
CLEAR
` / 1
NAME EDIT/SELECT
CLEAR
X
x
Press while the deck is
Stopped, playing, or paused
Recording the track
3
Turn AMS until "Nm In ?" appears, then press AMS
or YES.
While the deck is recording, a flashing cursor appears
in the display and you can enter a name for the track
being recorded. In this case, go to step 5.
4
Turn AMS until the track number (when naming a
track) or "Disc" (when naming the MD) flashes,
then press AMS or YES.
A flashing cursor appears.
The deck starts playing and you can name a track
while monitoring the sound.
5
Press LEVEL/DISPLAY/CHAR repeatedly to select
the character type.
To select
Uppercase letters
Lowercase letters
Numbers
Symbols 1)
1) You can use the following symbols in titles:
' – / , . ( ) : ! ? & + < > _ = " ; # $ % @ * `
To enter a space
Press M while the cursor is flashing. You cannot
enter a space as the first character.
6
Turn AMS to select the character.
The selected character flashes.
To change a selected character
Repeat steps 5 and 6.
7
Press AMS.
The selected character is entered and lights
continuously. The cursor shifts to the right, flashes,
and waits for the input of the next character.
8
Repeat steps 5 to 7 to enter the rest of the name.
To change a character
Press m/M repeatedly until the character to be
changed flashes, then repeat steps 5 to 7.
Press repeatedly until
"A" appears in the display
"a" appears in the display
"0" appears in the display
" ' " appears in the display
35
Naming a track or MD