Cisco VG202 Quick Start Manual page 17

Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity for management of the system, extended setup
will ask you to configure each interface on the system
Would you like to enter basic management setup? [yes/no]: yes
Enter a hostname for the voice gateway:
Step 4
Configuring global parameters:
Enter host name [VG]: VG
Step 5 Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when viewing the
configuration.
The enable secret is a password used to protect access to privileged EXEC and configuration modes. This
password, after entered, becomes encrypted in the configuration.
Enter enable secret: xxxxxx
Enter an enable password that is different from the enable secret password. This password is not encrypted (less secure)
Step 6
and can be seen when viewing the configuration.
The enable password is used when you do not specify an enable secret password, with some older software
versions, and some boot images.
Enter enable password: xxxxxx
Enter the virtual terminal password, which prevents unauthenticated access to the voice gateway through ports other
Step 7
than the console port:
The virtual terminal password is used to protect access to the voice gateway over a network interface.
Enter virtual terminal password: xxxxxx
Respond to the following prompts as appropriate for your network:
Step 8
Configure SNMP Network Management? [yes]:
Community string [public]:
The system displays a summary of the available interfaces.
Choose one of the available interfaces for connecting the voice gateway to the management network:
Step 9
Enter interface name used to connect to the management network from the above interface summary:
fastethernet0/0
Step 10 Respond to the following prompts as appropriate for your network:
Configuring interface FastEthernet0/0:
Use the 100 Base-TX (RJ-45) connector? [yes]: yes
Operate in full-duplex mode? [no]: yes
Configure IP on this interface? [yes]: yes
IP address for this interface: 172.1.2.3
Subnet mask for this interface [255.255.0.0] : 255.255.0.0
Class B network is 172.1.0.0, 26 subnet bits; mask is /16
The system displays the configuration:
The following configuration command script was created:
hostname VG
enable secret 5 $1$D5P6$PYx41/lQIASK.HcSbfO5q1
enable password xxxxxx
line vty 0 4
password xxxxxx
snmp-server community public
!
no ip routing
!
interface FastEthernet0/0
no shutdown
speed 100
duplex auto
17