Advertisement
VeraEdge Buttons
A
Sync Button
To carry out a manual setup of devices, tap the Sync button on the
controller. To exit the inclusion mode on the controller, tap the
Sync button again. To exclude a Z-Wave product from the network,
hold the Sync button down for 3 seconds. (Figure 2-1)
B
WPS Button
Easy push button inclusion for Wi-Fi devices. (Figure 2-1)
Reset Button
C
The Vera Edge controllers can be reset to factory defaults by
holding the reset button for 20 seconds and releasing it. This will
reset the Z-Wave network and change it's House ID, and clear your
account and user configuration data from your controller.
The account will only be removed from the controller, but it will
continue to be in the database.
Holding the reset button for 10 seconds will reset the network
configuration settings to defaults, while keeping your other
settings intact. (Figure 2-1)
Note: Please use this procedure only in the event that the system
primary controller is missing or otherwise inoperable.
Figure 2-1:
VeraEdge Left Side
A
B
C
Advertisement
