Texas Instruments 990 Operation Manual page 80

~
____
9_4_S2_S_S_~_7_01
______________________________________________ ___
Parameters:
starting snapshot no.
ending snapshot no.
Parameter default values:
Index number (number of the snapshot in
sequence) of the first snapshot to be
displayed. A number from 0 to 3.
Index number of the last snapshot to be
displayed. A number from 0 to 3.
If neither the starting snapshot number nor the ending snapshot number is specified, all
snapshots are displayed.
If the starting snapshot number but not the endmg snapshot number is specified, the named
snapshot is displayed.
If the ending snapshot number but not the starting snapshot number is specified, the snapshots
from 0 through the specified snapshot are displayed.
Description: Snapshots are defined with the Set Snapshot command. Attempts to display
undefined snapshots are ignored.
DP13 Either the ending snapshot number is greater than
Examples:
.IS
SNAPO
the starting snapshot number, or a snapshot number
greater than the permitted maximum was input. Re-
enter the command with the correct snapshot numbers.
RO=OOOO Rl=OOOO R2=0000 R3=OOOO R4=0007 R5=OO89 R6=0000 R7=OOOO
R8=0000 R9=0000 RA=OOOO RB=OOOO RC=OOOO RD=OOOO RE=OOOO RF=OOOO
0000=0000
SNAPl
R2=0000 R3=0000 R4=0007 R5=0089
1000=0001 0003
.IS 1,3
SNAPl
R2=OOOO R3=0000 R4=0007 R5=0089
1000=0001 0003
.IS 3
3-42 Digital Systems Division