Sony DAR-RD100 Operating Instructions Manual page 22

Connecting the audio cords
If you use your TV's speakers for listening to sound, connect the LINE 2 OUT jacks of the recorder to
the audio input jacks of your TV.
z Hint
You can connect an AV amplifier to the DIGITAL OUT
(COAXIAL) jack. Make the appropriate settings under
[Audio] setup (page 79). All the surround effects of the
system cannot be used.
Notes
• Do not connect your TV's audio output jacks to the
LINE IN (AUDIO L/R) jacks at the same time. This
will cause unwanted noise to come from your TV's
speakers.
• Do not connect the LINE 4 IN (AUDIO L/R) and LINE
2 OUT (AUDIO L/R) jacks to your TV's audio output
jacks at the same time. This will cause unwanted noise
to come from your TV's speakers.
22
(white)
LINE 2 OUT
L
AUDIO
(red)
R
VIDEO
to LINE 2 OUT (AUDIO L/R)
AERIAL LINE 3 / DECODER DIGITAL OUT COMPONENT
LINE 2 OUT
VIDEO OUT
COAXIAL
IN
PCM/DTS/
MPEG/
L
DOLBY DIGITAL
P /C
B B AUDIO
VIDEO OUT
LINE 2 OUT
SELECT
LINE 1 - TV
RGB R
P R /C R
OUT
COMPO-
Y
NENT VIDEO
S VIDEO
: Signal flow
Audio cord
(white)
(not supplied)
(red)
LINE 4 IN
L
AUDIO
DIGITAL OUT
R
PCM/DTS/MPEG/
DOLBY DIGITAL
OPTICAL
VIDEO
To use the recorder's surround function
With the audio connection above, you can enjoy
virtual surround sound effects created from the left
and right speakers.
Press SUR on the remote to turn on the function.
[SUR ON] appears on the TV screen
To turn off the function, press SUR again.
INPUT
VIDEO
L
AUDIO
R
TV, projector, or AV
amplifier (receiver)