Sony CMT-WS2D Operating Instructions Manual page 9

2 Connect the FM and AM antennas.
Set up the AM loop antenna, then connect
it.
Extend the FM lead
antenna horizontally
AM loop antenna
* Strip off an end-portion of wire covering.
Note
Keep the antennas away from the speaker cords.
3 Connect the video input jack of your TV
to the VIDEO OUT jack with the
supplied video cable.
When using a TV
Turn on the TV and select the video input so that you
can view the pictures from this system.
When connecting a video deck
Connect the TV and the video deck using video and
audio cords (not supplied) as shown below.
TV
Video deck
If the picture has disturbance or there is noise in the
audio when a TV, a video deck and this system are all
connected at the same time, disconnect one of them.
Note
Do not place the TV on this system.
Tip
For even higher quality video images:
– Use an optional component video cord to connect the
Insert only the
stripped portion*
– You can use an optional S video cord to connect the
4 For models with a voltage selector, set
5 Connect the power cord to a wall
System
COMPONENT VIDEO input jacks on your TV to
the COMPONENT VIDEO OUT jacks of this
system. If your TV is compatible with progressive
format file signals, use this connection and set
"PROGRESSIVE AUTO" or "PROGRESSIVE
VIDEO" depending on your TV. For details, see "To
change the type of signal output from the system"
(page 35).
S VIDEO input jack on your TV to the S VIDEO
OUT jack.
the VOLTAGE SELECTOR to the local
power line voltage.
Depending on the model, the VOLTAGE
SELECTOR may differ.
220-240V
120V
VOLTAGE
SELECTOR
outlet.
The demonstration appears in the display.
When you press ?/1
and the demonstration automatically ends.
If the supplied adapter on the plug does not
fit your wall outlet, detach it from the plug
(only for models equipped with an adapter).
, the system turns on
continued
GB
9