Creating Your Own Program; Program Play - Sony CMT-M90DVD Operating Instructions Manual

Creating your own
program

— Program Play

You can make a program of up to 25 steps.
Using the front panel display
1
Press FUNCTION repeatedly to switch
the function to DVD.
2
Press PLAY MODE/TUNING MODE in
stop mode repeatedly until "PGM"
appears.
3
Press DVD . or > on the remote
repeatedly until the desired title or
track number appears.
When programming a DVD, press ENTER/
YES on the remote, then press DVD .
or > on the remote repeatedly until the
desired chapter number appears.
Selected title or track number
PGM TITLE
4
Press ENTER/YES on the remote.
The title/chapter, or track is programmed.
The step number appears, followed by the
last programmed title or track number.
If you made a mistake, you can clear the last
step from the program by pressing CLEAR
on the remote.
Last programmed title
or track number
TITLE
PGM
GB
14
DVD
Total playing time
MIN SEC
DVD
5
To programme additional tracks, repeat
steps 3 and 4.
6
Press DVD N.
Other operations
To
Do this
Cancel Program
Press PLAY MODE/TUNING
Play
MODE in stop mode repeatedly
until both "SHUFFLE" and
"PGM" disappear.
Check the Press DVD . or > on the
program order
remote repeatedly during Program
Play.
Add a track to
Perform steps 3 and 4 in stop
the end of the
mode.
program
Tips
• The program you made remains after Program Play
finishes. To play the same program again, press
DVD N. However, the program is cleared when
you open the disc tray.
• "---.--" appears when the total program time
exceeds 1000 minutes, or when DVD titles/chapters
are programmed.
Note
Depending on the DVD, you cannot use Program
Play.